Table of Contents
Advertisement
TOP-PCVIEW Hardware Manual
5. After rebooting ENABLED status
6. Press the button DISABLED during commit, press the Disable button.
- If you do not press all of the contents in the temporary space had to switch to DISABLED state as initialized commit.
* The EWF function may not work normally when restoring to the factory default state. If you need the function,
please contact M2I CORPORATION.
8.4. Backlight brightness settings
You can adjust the display brightness to suit your needs. Adjustable in five steps, and the default settings are to Highest.
To use other settings must be selected in CMOS.
1. boot <DEL> or <ESC> Press the key to enter the CMOS screen.
2. Select the Advanced -> Embedded Controller Configuration -> Backlight Level
3. Adjust the desired brightness at the bottom of the screen.
4. Select the Save & Exit -> Save changes and Exit.
24 / 33
M
I Corporation
2
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr
Advertisement
Table of Contents
