Page 1
Thank you for using TOP-PCVIEW series of M2I corporation. Please read this manual carefully to know installing, wiring, operating, servicing and inspecting this equipment. 1 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Altitude up to 2000m. Wiring Precautions Be sure the wiring is done correctly by checking the product’s rated voltage and the terminal 4 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
All field-wiring connections to this unit shall be from Limited Voltage / Limited below 24Vdc isolated secondary source with an output fuse, or Class 2. 5 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
3.10 Options Specifications Windows Embedded Standard 7 32/64bit KOR/ENG Ver. Windows Professional for Embedded System Ver. USB KEY TOPVIEW usb key certification 8 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
TOP-PCVIEW19 497 x 316 x 86.6 Cooling System Natural air circulation Case Material AL(Aluminium) Chapter 4. Parts Identification and Functions 4.1 TOP-PCVIEW10 9 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 13
If the screw is over tightened, it may cause the front deformation, thus resulting the touch sensor can’t work properly. Tighten the screw to 0.5 Nm. 13 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
(2) Gender Remove: Hold down the button below and pull back the USB gender. Push (3) Close the cover: Close and slide the cover of the connector. * Locker type USB cover is required for front USB gender use. Please contact M2I Corporation. 14 / 33 I Corporation...
(4) The communication mode can be set as the table below. COM1 COM2 COM3 COM4 Manufacturer status RS-232C RS-232C RS-485 RS-485 RS-232C RS-232C Available settings Not available Not available RS-422 RS-422 15 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 16
RS-232C Receive Data RS-232C Transmit Data 9Pin male Data Terminal Ready Signal Ground Data Set Ready Request to Send Clear to Send Ringing Indicator 16 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Speed 10M / 100M / 1000M bps Communication Method Base Band Communication Cable UTP (Unshielded Twisted Pair) Modular Jack RJ-45 x 2 17 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Common ground (4) Use the cable more than 4mm . Put the point of the ground near TOP PC and shorten ground line. 19 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
* If there is no recovery file on the right, select [Browse Backup]-> [Acronis Secure Zone]-> Restore File on the right side of the screen. 2) [Recovery method]: Select "Recover whole disks and partitions" 20 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Do not correction from a sharp object. improve accuracy when you hold down the exact location, such as a stylus pen. 22 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
1. When you run the EWFManager of the Start menu as shown below will run the program. 2. The default status of EWFManager is set to DISABLED. 3. Set to ENABLED. 4. reboot will be ENABLED state. 23 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
3. Adjust the desired brightness at the bottom of the screen. 4. Select the Save & Exit -> Save changes and Exit. 24 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
If you see the message below when booting up, press "CTRL + I" key to enter RAID configuration screen. If RAID is already existing, only 1 and 6 can be selected as below, and Disk information is displayed as Non-RAID. 25 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 26
If you do not need RAID, you can delete it by using menu 2 (delete RAID Volume). When executing the menu No. 2, the delete menu appears as shown below. Enter "Del" key when deleting. 26 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 27
AHCI mode again. Select the disk you want to reset and press "Enter". It is a window to check again whether user request is correct. Press "Y". 27 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 28
RAID configuration (RAID1) that you created previously. (It is also possible with the intel RST utility of the OS) After the addition, you need to rebuild from Intel RST utility in OS. Select "Exit" for Rebuild and exit. 28 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 29
If a new hard disk is connected due to a failure of one disk, a window asking whether you want to rebuild the new disk will appear as shown below. At this time, click "rebuild to another disk" to rebuild. 29 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Page 30
After the recovery, the recovery solution will be disabled. Be sure to click "Tools & Utilities" - "Activate "Acronis Startup Recovery Manager" - "Activate". 30 / 33 I Corporation 11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr...
Only the authorized worker from M2I Corporation can check and repair problems related to malfunction of the machine. c. If the problem cannot be solved at the installation site, the equipment can be collected and moved to M2I Corporation.
Copyright: M2I corporation 2020.12 www.m2i.co.kr - When using M2I equipment, thoroughly read this datasheet and associated manuals introduced in this datasheet, also pay careful attention to safety and handle the module properly. - Store this datasheet in a safe place so that you can take it out read it whenever necessary.
Need help?
Do you have a question about the TOP-PCVIEW Series and is the answer not in the manual?
Questions and answers