Icon Process Controls truflo TIB Series Quick Start Manual page 8

Gauges are not to be subject to water hammer or pressure spikes!
WARNING!
Before installation be certain the appropriate gauge has been selected considering operating pressure / full scale pressure /
proof pressure, wetted material requirements, media compatibility, operating temperature, vibration, pulsation, desired
accura-cy and any other gauge component related to the service application (including the potential need for protective
attachments and/or special installation requirements). Failure to do so could result in equipment damage, gauge failure and/or
personal
Gauges are not to be subject to water hammer or pressure spikes!
WARNING!
Before installation be certain the appropriate gauge has been selected considering operating pressure / full scale pressure /
proof pressure, wetted material requirements, media compatibility, operating temperature, vibration, pulsation, desired
accura-cy and any other gauge component related to the service application (including the potential need for protective
attachments and/or special installation requirements). Failure to do so could result in equipment damage, gauge failure and/or
personal
IMPORTANT!
When installing the gauge connection into the
application, use the wrench area to thread in and tighten
the gauge. Do not use the gauge case to install the
gauge.
Hand Tighten Using the Retention Cap
This could result in loss of accuracy, excessive friction, or
mechanical damage to the pressure element or gauge
case. The gauge connection must be compatible with the
mating connection and must be assembled appropriately. If
IMPORTANT!
the mating parts do not seal completely, a sealing material
may be considered.
When installing the gauge connection into the
application, use the wrench area to thread in and tighten
the gauge. Do not use the gauge case to install the
gauge.
This could result in loss of accuracy, excessive friction, or
mechanical damage to the pressure element or gauge
case. The gauge connection must be compatible with the
mating connection and must be assembled appropriately. If
the mating parts do not seal completely, a sealing material
may be considered.
ICON
PROCESS CONTROLS
ICON
PROCESS CONTROLS
Do Not Use Display to Tighten
Manufacturer Reserves the Right to Implement Changes Without Prior Notice.
™
Corros
Instrumen
Manufacturer Reserves the Right to Implement Changes Without Prior Notice.
™
Corros i on
Instrumen
IMPORTANT!
IMPORTANT!
i on - Free
Ensure Silicone Grease* is Applied
t at i on Equ
to O-Rings Prior to Insertion into Fitting
*Ensure Silicone Grease is Suitable for Application
- Free
t at i on Equ
i pm e nt
i pm e nt