Advertisement
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
FT-347F (267 lbs)
35.75"L x 35.75"W x 13"H
FT-347D (17 lbs)
9.5"L x 9.5"W x 7.75"H
FT-347C (63 lbs)
21.25"L x 21.25"W x 7"H
FT-347 Facet Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Fountain Set-Up:
Assemble your fountain on a level surface capable of holding a minimum of 503 lbs with an
approximate 1.75 sq. ft. footprint (actual dimensions 16" x 16").
Step 1 - Position the basin (FT-347F) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the fountain plumbing:
2a - Secure the tubing to the pump by tightening the hose clamp.
2b - Place the stopper around the pump cord approximately 8" from the pump.
Step 3 - Feed the pump cord all the way through the hole in the basin and run the cord through
the channel in the bottom to ensure the fountain will be level.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper in
place.
Step 5 - Place the pump cover (FT-347D) over the pump. Ensure it is centered and leveled.
Step 6 - Position the small bowl (FT-347C) over the pump cover (FT-347D).
Step 7 - Insert the CPVC end of the tubing assembly into the pipe protruding from the bottom of
the small bowl (FT-347C).
Step 8 - Center the small bowl (FT-347C) on top of the pump cover (FT-347D).
Step 9 - Insert the 6½" length of copper pipe into the CPVC coupling protruding up from the
center of the small bowl (FT-347C).
Step 10 - Using the silicone provided, secure the copper spillers to the four lips of the small bowl
(FT-347C).
Advertisement
