YARDART Soma Pebble FT-365 Assembly Instructions

Fountain Components
Image Item Description
Salinas Pebble
Fountain, Low -
Water Feature
Soma Pebble
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• Two people are recommended for the installation of this fountain!
• This fountain holds approximately 5 gallon of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• No refill device or submersible lights are suggested for this fountain.
Pump Information:
OEMPF140 - 140 GPH Pump (6 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Component
Quantity
Item #
FT-381A
1
Fountain -
FT-365B 1
Basin
Fountain Set-Up:
FT-365 Soma Pebble Fountain
Assembly Instructions
Pump Kit Parts List
Image
(use only large adapter)
Approx. 25" length of 1/2" black
Approx. 1.5" length of 5/8" clear vinyl
Approx. 1.5" length of 1/2" CPVC pipe
Proudly
MADE IN USA
Component Quantity
PK140 Pump
#7 Stopper
non-kink tubing
tubing
PEBBLES-5
Hose Clamps
1
1
1
1
1
1
1
rev 8/18/21