Recycling And Disposal - Titan TTHTP26 Manual

TTHTP26
Problem
Engine does not
reach
the maximum
speed.
Engine starts
but does not
accelerate.
Bad cutting
performance.
Excessive
vibration/noise or
smoke.

Recycling and disposal

1. Old equipments are potentially recyclable and do not, therefore, belong in your
household rubbish. You are requested to assist us and our contribution to saving
resources and protecting the environment by handing in this equipment to an equipped
collection centre (if there is one available).
2. Petrol, oil, used oil, a mixture of oil and petrol and objects soiled with oil e.g. cleaning
cloths do not belong in the household rubbish. Dispose of oil-contaminated items in
accordance with the local guidelines and hand them in at recycling centres.
3. The equipment comes in a package that protects it against damage during shipping.
Keep the package until you are sure that all parts have been delivered and the
equipment is operating properly. Recycle the package afterwards.
5059340124346-TTHTP26-GB-V01.indd 37 5059340124346-TTHTP26-GB-V01.indd 37
Troubleshooting / Recycling and disposal
Possible cause
Air filter is soiled?
Incorrect fuel or incorrect
mixture?
Carburetor setting not
correct?
Engine is not warmed up?
Cutting device is worn?
Thickness of the branches
exceeds capacity.
Cutting device damaged?
Nuts on the cutting device
loosen?
Incorrect fuel or incorrect
mixture?
Solution
Clean the air filter.
Stop the engine, empty tank, then
fill up with the correct mixture of
fuel to oil (40:1).
Have a qualified person adjust the
carburetor.
Allow engine to warm up at idle
speed for 2-3 minutes.
Have a qualified person sharpen or
replace the cutting device.
Only cut branches with a diameter
of maximum 20 mm.
Have a qualified person replace
the cutting device.
Stop the engine and re-tighten the
loosen nuts.
Stop the engine, empty tank, then fill
up with the correct mixture of fuel to
oil (40:1).
37
18/9/2020 9:55 AM 18/9/2020 9:55 AM