Parts List; Product Use; Installation Concerns - Nuna PIPA next Manual

Parts List

Make sure all parts are available before assembly. The
infant carrier module and base can be sold separately.
If any part is missing, please contact Nuna (see page
2 for information). No tools are required for assembly.
1 ISOFIX Connector
2 ISOFIX Guides
3 Load Leg Adjust
Button
4 Side Impact Shield
5 ISOFIX Adjust Button
5
1
2
5
PIPA next base instructions
6 Infant Carrier Module
Release Button
7 Load Leg Indicator
8 Instruction
Manual Storage
Compartment
6
4
7
8
3

Product Use

Installation Concerns

DO NOT install this enhanced child restraint on vehicle
seats that face sideways or rearward with respect to
the moving direction of the vehicle. (1)
Installation
1
Unfold the load leg from storage compartment.
(2)
2
Fit the ISOFIX guides with the ISOFIX anchor
points. (3) The ISOFIX guides can protect the
surface of the vehicle seat from being torn. They
can also guide the ISOFIX connectors.
3
Press the ISOFIX Adjust Button to adjust the
ISOFIX connectors. (4)
4
Line up the ISOFIX connectors with the ISOFIX
guides, and then click both ISOFIX connectors
into the ISOFIX anchor points. (5)
Make sure that both ISOFIX connectors are
securely attached to their ISOFIX anchor points.
There should be two audible clicks and the colors
of the indicators on the both ISOFIX connectors
should be completely green. (5)-1
Check to make sure the base is securely installed
by pulling on the both ISOFIX connectors.
6
PIPA next base instructions