Advertisement

Harness: Shoulder straps are attached to a splitter plate behind seat. Pull
strap end in front of seat to tighten harness. Push button at lower front of
seat and pull on shoulder straps to loosen.
Harness slots: There are three sets of slots. To change shoulder strap slot
height, remove straps from splitter plate on back and rethread through
desired slots, then reattach to splitter plate. Harness straps must be
between child restraint and attachment bar (diagram 1).
Crotch strap: Adjustable. There are two slots; length is also adjustable.
Crotch strap is sewn to a metal anchor which must lie flat against
underside of seat. Use position closest to, but not under, child. To change
position, turn metal anchor sideways, feed through slot, and insert into
desired slot. To shorten length for smaller child, feed metal anchor down
through inner slot and up through outer slot (diagram 2).
Angle adjustment: Recline adjustment button and indicator are
located on both sides of the base (diagram 3). To adjust, push button
all the way down and slide installed carrier or top of base into desired
position. Use positions 1 or 2 for child weighing 4 to 20 lbs. and
positions 3 or 4 for child weighing 21 to 32 lbs. Recline button must
pop back up to indicate recline is locked.
Belt path: If lower connectors are not in use, leave connectors
rotated in place on side of base (diagram 4). Do not install restraint
using inflatable safety belt.
SEE PAGE 2
Important: This information sheet is not a substitute for complete manufacturer's directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 318-5111 (800)745-SAFE ©SafetyBeltSafe U.S.A. #450 06/21
NUNA
Type: Rear-facing-only; must be used
with base in vehicle.
Last date made: Current
First made: 2020
Weight limits: 4 to 32 lbs.
Harness: 5 point harness
PIPA LITE R
P. 1 of 3
1
2
3
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PIPA LITE R and is the answer not in the manual?

Questions and answers

Summary of Contents for Nuna PIPA LITE R

  • Page 1 P. 1 of 3 PIPA LITE R NUNA Type: Rear-facing-only; must be used with base in vehicle. Last date made: Current First made: 2020 Weight limits: 4 to 32 lbs. Harness: 5 point harness Harness: Shoulder straps are attached to a splitter plate behind seat. Pull strap end in front of seat to tighten harness.
  • Page 2 P. 2 of 3 Nuna Pipa Lite R Belt Path: With base: (cont.) Press release button on bottom of base to release stability leg (diagram 5). Open lock-off and route vehicle belt over base and buckle. Route lap belt under tabs in lap belt path, route shoulder belt diagonally over shoulder belt path under lock-off.
  • Page 3 P. 3 of 3 Nuna Pipa Lite R LATCH: (cont.) Base bottom has three retraction positions (diagram 10). Use of retraction may be necessary in some vehicles to allow base to sit against vehicle seat back. If there is a gap between back of base and vehicle seat back after connectors are attached, push base into seat until it makes contact with vehicle seat back and a “click”...
  • Page 5 Designed around your life Easy Installation Our products are designed to make your life easier, so installing this child restraint doesn't require outside assistance. While we encourage the use of Certified Child Passenger Safety Technicians to ensure you have installed the seat correctly, you can install the restraint in your vehicle without these professionals by carefully reading...
  • Page 6: Table Of Contents

    Base Parts List ™ REFERENCE: Product Overview READ CAREFULLY Using PIPA lite r ™ Product Use Installation With PIPA RELX base ™ In an Aircraft On a Stroller Accessories Cleaning and Maintenance PIPA lite r instructions PIPA lite r instructions...
  • Page 7: Product Information

    1.855.NUNA.USA please contact our customer service department. or register online at: www.nunababy.com In the USA: Click on the “Register Car Seat” link infousa@nunababy.com on the homepage. www.nunababy.com 1.855.NUNA.USA PIPA lite r instructions PIPA lite r instructions...
  • Page 8: Child Usage Requirements

    See page 11 Use the bottom of the base for to learn what is classified as a instruction manual storage. moderate to severe crash. PIPA lite r instructions PIPA lite r instructions...
  • Page 9 To find out if damaged can fall from a shopping cart. parts are replaceable, call DO NOT use on 1-855-NUNA-USA. a shopping cart. NEVER modify any part of the child restraint. PIPA lite r instructions PIPA lite r instructions...
  • Page 10: Car Seat Use After A Crash

    Car Seat Use after DO NOT use any products or accessories with this child a Crash restraint unless they are approved by Nuna for use The National Highway Traffic with this child restraint. Doing Safety Administration (NHTSA) so may be unsafe and may recommends that car seats be void the warranty.
  • Page 11: Vehicle Compatibility

    Airbags inflate with great force and can cause severe injury to a child’s neck and spine. PIPA lite r instructions PIPA lite r instructions...
  • Page 12 This belt cannot be used to install this child restraint. - Lap Belts forward of Seat Bight This belt (Where the seat bottom and seat back meet) should not be used to install this child restraint. PIPA lite r instructions PIPA lite r instructions...
  • Page 13: Pipa

    PIPA lite r ™ Parts List Make sure all parts are available before assembly. If any part is missing, please contact Nuna (see page 5 for information). No tools are required for assembly. Canopy Seat Pad Body Support Chest Clip...
  • Page 14: Pipa Relx

    Child Restraint Release Button 10 Stability Leg Stability Leg Adjustment Button 12 Stability Leg Indicator 13 Stability Leg Storage Release Button 14 Stability Leg Storage 15 Instruction Manual Storage (under Stability Leg) PIPA lite r instructions PIPA lite r instructions...
  • Page 15: Product Overview

    (1) and pull canopy through the fabric slot (2). Repeat on opposite side. Shoulder Harness Pads - Shoulder harness pads are removable. Buckle Holders - Loosen and unfasten harness. Place buckle tongues in buckle holders. PIPA lite r instructions PIPA lite r instructions...
  • Page 16 Seat Pad - Open the snaps on both sides of the seat. - Turn child restraint over and remove the harness straps from the splitter plate. - Remove the seat pad. 22 PIPA lite r instructions PIPA lite r instructions...
  • Page 17 The body support can be used for smaller babies, but MUST be removed once a snug fit can be achieved without it, at approximately 11 pounds. PIPA lite r instructions PIPA lite r instructions...
  • Page 18 - Pull loose ends of harness loop out through slots and place in correct slot. - Repeat process for second shoulder harness strap and then re-attach harness to splitter plate. PIPA lite r instructions PIPA lite r instructions...
  • Page 19 An unlocked handle could move unexpectedly, 1 in. causing injury to child. Handle 25 mm MUST NOT contact the vehicle interior (side of car or seat in front) when installed. PIPA lite r instructions PIPA lite r instructions...
  • Page 20: Product Use

    DO NOT allow child to slouch. Gently guide child’s arms through harness loops. - Insert buckle tongues into buckle and listen for clicks. Pull on buckle to verify it is latched. 30 PIPA lite r instructions PIPA lite r instructions...
  • Page 21 Check that Child is Secure Buckle is fastened. Harness straps are not twisted. Harness is snug – A snug harness cannot be pinched horizontally, and should not allow any slack. Chest clip is level with armpits. PIPA lite r instructions PIPA lite r instructions...
  • Page 22 If the stability leg indicator shows red, the stability leg is not making firm contact with the vehicle floor. Adjust as needed. Stability leg should be perpendicular to the floor. (continued on the next page) 34 PIPA lite r instructions PIPA lite r instructions...
  • Page 23 Push until the release button clicks into place. The stability leg can be used or stored for both rigid latch and vehicle belt installation. 36 PIPA lite r instructions PIPA lite r instructions...
  • Page 24: Installation

    Be sure that the base bottom is firmly seated on vehicle seating surface and there is no gap between the base bottom and vehicle seat. (continued on the next page) 38 PIPA lite r instructions PIPA lite r instructions...
  • Page 25 “click” indicates it’s locked into a retracted position. A gap is acceptable if the base clicks through all retracted positions but is still not fully against the vehicle seat. (continued on the next page) 40 PIPA lite r instructions PIPA lite r instructions...
  • Page 26 It is acceptable to install with both rigid latch and the vehicle belt. (See vehicle belt installation on the next page.) 42 PIPA lite r instructions PIPA lite r instructions...
  • Page 27 - While pressing the base firmly downward onto the vehicle seat, (1) tighten the vehicle belt by pulling upward on the shoulder belt (2). (continued on the next page) 44 PIPA lite r instructions PIPA lite r instructions...
  • Page 28 There should be no gap between the vehicle seat and the bottom of the base. It is acceptable to install with both rigid latch (p.38) and the vehicle belt. 46 PIPA lite r instructions PIPA lite r instructions...
  • Page 29 Gently push or pull the top of the base until it locks into position. (continued on the next page) 48 PIPA lite r instructions PIPA lite r instructions...
  • Page 30 When Installed with Lap and Lap/Shoulder Belt: - Lift the lock off release button. - Unbuckle the vehicle belt and un- route the shoulder and lap belt from the base. Remove the base. 50 PIPA lite r instructions PIPA lite r instructions...
  • Page 31: In An Aircraft

    Installation on a Stroller This infant carrier can attach to Nuna strollers as well as other brands of strollers using adapters (see next page). Adapters are sold separately. Visit nunababy.com for more information.
  • Page 32: Accessories

    This infant carrier can also attach to other brands of strollers using adapters. Visit nunababy.com for more information. PIPA series base PIPA lite r is also compatible with the PIPA series base, sold separately. 54 PIPA lite r instructions PIPA lite r instructions...
  • Page 33: Cleaning And Maintenance

    Check regularly if everything functions properly. If any parts are torn, broken, or missing, stop using this product. Nuna Baby Essentials, Inc. Nuna and all associated logos are trademarks. 56 PIPA lite r instructions...

Table of Contents