Rack-Mount Setup - Eaton Powerware 9125 Installation Manual

Hide thumbs Also See for Powerware 9125:

Table of Contents

Rack-Mount Setup

The rail kit can be mounted in 48-cm (19-inch) panel racks from 61 to

76 cm (24 to 30 inches) deep.

NOTE Mounting rails are required for each individual cabinet and are located in the UPS

and EBM cartons. The UPS requires 5U and each EBM requires 3U of rack height. All

hardware is supplied.

NOTE The UPS and any optional cabinets MUST be installed at the bottom of the rack. If

placed in a rack with existing equipment, the rack must be reconfigured to allow the UPS

installation at the bottom of the rack.

Each rail kit requires one (1) of each item in the following list:

Left adjustable rail assembly (located in the UPS and EBM cartons)

Right adjustable rail assembly (located in the UPS and EBM cartons)

Rail hardware kit (located in the E64 UPS and EBM accessory kits)

To install the rail kit(s):

Loosen the assembly wing nuts on both rail assemblies and adjust

the rail size for the depth of your rack (see Figure 1).

Front

Rail Assembly

Select the proper holes in the rail for positioning the UPS and any

optional cabinets in the rack.

Place the first rail at the bottom, using positions 1 and 6 for the

front pan-head screws. If you are installing additional rails, place the

next rail 4 holes above the last installed screw (see Figure 2).

EATON Powerware

9125 (9910-E64) UPS Installation Guide for IBM

Assembly Wing Nuts

Figure 1. Adjusting the Rail Depth

Applications

164201697 Rev 1

INSTALLATION

Rear

Table of Contents

9910-e64