Table of Contents
Advertisement
accessories that may be required by law, such as
lights, turn signals, slow-moving vehicle (SMV)
signs, and others as required.
•
If the machine ever vibrates abnormally, stop the
machine immediately, shut off the engine, remove
the key, wait for all moving parts to stop, and
inspect for damage. Repair all damage to the
machine before resuming operation.
•
Reduce speed when operating on rough, uneven
terrain, and near curbs, holes, and other sudden
changes in terrain.
•
To avoid causing the machine to tip over, be
careful when turning and avoid unsafe maneuvers.
Slope Safety
•
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. You are responsible for safe slope
operation. Operating the machine on any slope
requires extra caution.
•
Review the traction unit specifications to ensure
that you do not exceed its slope capabilities.
•
Evaluate the site conditions to determine if the
slope is safe for machine operation, including
surveying the site. Always use common sense
and good judgment when performing this survey.
•
Review the slope instructions, listed below, for
operating the machine on slopes. Before you
operate the machine, review the site conditions to
determine whether you can operate the machine
in the conditions on that day and at that site.
Changes in the terrain can result in a change in
slope operation for the machine.
– Avoid starting, stopping, or turning the machine
on slopes. Avoid making sudden changes in
speed or direction. Make turns slowly and
gradually.
– Do not operate a machine under any conditions
where traction, steering, or stability is in
question.
– Remove or mark obstructions such as ditches,
holes, ruts, bumps, rocks, or other hidden
hazards. Tall grass can hide obstructions.
Uneven terrain could overturn the machine.
– Be aware that operating the machine on wet
grass, across slopes, or downhill may cause
the machine to lose traction.
– Use extreme caution when operating
the machine near drop-offs, ditches,
embankments, water hazards, or other
hazards. The machine could suddenly roll over
if a wheel goes over the edge or the edge
caves in. Establish a safety area between the
machine and any hazard.
Starting the Engine
WARNING
Rotating parts can cause serious personal
injury.
• Keep hands and feet away from the
machine when it is running.
• Keep hands, feet, hair, and clothing away
from all moving parts to prevent injury.
• Never operate the machine with covers,
shrouds, or guards removed.
1.
Ensure that the blower is attached to the tow
vehicle before you start the blower.
2.
Move the choke control to the O
starting a cold engine.
Note:
A warm or hot engine may not require
choking. After the engine starts, move the choke
control to the O
3.
Rotate the engine ignition key clockwise to the
S
position to start the engine; release the
TART
key whent he engine starts
Note:
If the key was left in the R
for an extended time, move the key to the
O
position before proceeding to the starting
FF
procedure.
Important:
Do not engage starter for more
than 10 seconds at a time. If engine fails
to start allow 10 second cool-down period
between attempts. Failure to follow these
instructions can burn out starter motor.
15
position before
N
position.
FF
(Figure
10).
position
UN
Advertisement
Table of Contents
