Table of Contents
Advertisement
This product complies with all relevant European
directives; for details, please see the separate product
specific Declaration of Conformity (DOC) sheet.
It is a violation of California Public Resource Code
Section 4442 or 4443 to use or operate the engine on
any forest-covered, brush-covered, or grass-covered
land unless the engine is equipped with a spark
arrester, as defined in Section 4442, maintained in
effective working order or the engine is constructed,
equipped, and maintained for the prevention of fire.
The enclosed engine owner's manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California Emission
Control Regulation of emission systems, maintenance,
and warranty. Replacements may be ordered through
the engine manufacturer.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same or
better ratings. Ensure that the tires meet or exceed
the weight requirements of your machine.
Electromagnetic Compatibility
Domestic: This device complies with FCC Rules Part 15.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device
must accept any interference that may be received, including
interference that may cause undesirable operation.
This equipment generates and uses radio frequency energy and
if not installed and used properly, in strict accordance with the
manufacturer's instructions, may cause interference to radio
and television reception. It has been type tested and found to
comply within the limits of a FCC Class B computing device in
accordance with the specifications in Subpart J of Part 15 of
FCC Rules, as stated above. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:Reorient the receiving
antenna, relocate the remote control receiver with respect to the
radio/TV antenna or plug the controller into a different outlet so
that the controller and radio/TV are on different branch circuits.If
necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.The
user may find the following booklet prepared by the Federal
Communications Commission helpful: "How to Identify and
Resolve Radio-TV Interference Problems". This booklet is
available from the U.S. Government Printing Office, Washington,
DC 20402. Stock No. 004-000-00345-4.
FCC ID: W7OMRF24J40MDME-Base,
OA3MRF24J40MA-Hand Held
IC: 7693A-24J40MDME-Base, 7693A-24J40MA-Hand Held
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Japan Electromagnetic Compatibility Certification
Handheld:
RF2CAN:
Mexico Electromagnetic Compatibility Certification
Handheld:
RF2CAN:
Korea Electromagnetic Compatibility Certification(Decal
provided in separate kit)
Handheld:
RF2CAN:
Singapore Electromagnetic Compatibility Certification
Handheld:
TWM240007_IDA_N4021–15
RF2CAN:
TWM-240005_IDA_N4024–15
Morocco Electromagnetic Compatibility Certification
AGREE PAR L'ANRT MAROC
Numero d'agrement:
Delivre d'agrement:
Important:
Changing or modifying the machine
without the express approval from the party
responsible for compliance could void your
authority to operate the equipment.
Do not change or modify the machine without the
express approval from the party responsible for
compliance.
2
MR 14092 ANRT 2017
29/05/2017
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
Advertisement
Table of Contents
