Starting And Stopping The Engine - Toro 44538 Operator's Manual

Starting and Stopping the
Engine
Starting the Engine
WARNING
ROTATING PARTS CAN CAUSE SERIOUS
PERSONAL INJURY
• Keep hands and feet away from the machine
when it is running.
• Keep hands, feet, hair, and clothing away from
all moving parts to prevent injury.
• NEVER operate the machine with covers,
shrouds, or guards removed.
1. Blower must be attached to the tow vehicle before it
can be started.
2. Move the choke control to the ON position before
starting a cold engine.
Note: A warm or hot engine may not require choking.
After engine starts, move choke control to off position.
3. Rotate the engine ignition key to the "START" position
and quickly release it to the "ON" position (Figure 10).
This wakes up the receiver .
Note: If the key was left in the on position for an
extended time, move the key to the off position before
proceeding to the starting procedure.
1
1. Choke control
2. Ignition switch
4. Engine Start will only become energized by pressing the
Start button while the Engine Start Enable Condition
is active. The Engine Start Enable Condition becomes
active only when the following Engine Start Enable
Sequence has been performed (Figure 11).
•
Press the START button.
•
Then, press the rotate left button.
G020713
Figure 10
3. Hour meter
•
Then, press the rotate right button.
•
Then, press and hold the START button until the
engine starts.
1. Rotate nozzle left
2. Rotate nozzle right
3. Decrease blower output
(Pressing 3 and 4 together
returns engine to idle)
Note: There is a time limit of 3 seconds between
2
each button press. If the next button in the sequence
is not press within 3 seconds of the last button press,
the sequence is aborted and must be started from the
beginning.
3
Note: If any button other than the next appropriate
button in the sequence is pressed the sequence is
aborted.
Note: If the Start button is not pressed within 25
seconds after pressing the Rotate Right button, or any
other button is pressed in this period, the Engine Start
Enable Condition expires
Note: Engine Start Enable Condition persists for 25
seconds after pressing the Rotate Right button allowing
momentary activation of Engine Start by pressing the
Start button. Pressing the Start button does not extend
this time period—the maximum length of time that the
Start Relay Control can be active is 25 seconds from
pressing the Rotate Right button. The Start button can
be pressed multiple times while Engine Start Enable
Condition is active. After the Engine Start Enable
Condition expires, the Engine Start Enable Sequence
must be performed again in order to energize the Start
Relay Control with the Start button.
13
1 2
3
4
5 6
g017705
Figure 11
4. Increase blower output
5. Engine start
6. Engine stop