Checking The Torque Of The Wheel Lug Nuts; Starting And Stopping The Engine - Toro 44539 Operator's Manual

Road-ready pro force debris blower
Hide thumbs Also See for 44539:
Table of Contents

Advertisement

Figure 13
Checking the Torque of the
Wheel Lug Nuts
Service Interval: After the first 10 hours
Check the torque of the wheel lug nuts initially and
after the first 10 hours of operation.
WARNING
Failure to maintain proper torque could result in
failure or loss of wheel and could result in personal
injury. Torque wheel lug nuts to 45-65 ft- lb (61-88
N-m).
Starting and Stopping the
Engine
Starting the Engine
WARNING
ROTATING PARTS CAN CAUSE SERIOUS
PERSONAL INJURY
• Keep hands and feet away from the machine
when it is running.
• Keep hands, feet, hair, and clothing away from
all moving parts to prevent injury.
• NEVER operate the machine with covers,
shrouds, or guards removed.
1. Blower must be attached to the tow vehicle before it
can be started.
2. Move the choke control to the ON position before
starting a cold engine.
Note: A warm or hot engine may not require
choking. After engine starts, move choke control
to off position.
3. Rotate the engine ignition key to the "START"
position and quickly release it to the "ON" position
(Figure 14). This wakes up the receiver .
Note: If the key was left in the on position for an
extended time, move the key to the off position
before proceeding to the starting procedure.
1
1. Ignition switch
2. Choke control
4. Engine Start will only become energized by pressing
the Start button while the Engine Start Enable
Condition is active. The Engine Start Enable
Condition becomes active only when the following
Engine Start Enable Sequence has been performed
(Figure 15).
• Press the START button.
• Then, press the rotate left button.
• Then, press the rotate right button.
• Then, press and hold the START button until
the engine starts.
Note: There is a time limit of 3 seconds between
each button press. If the next button in the
sequence is not press within 3 seconds of the last
button press, the sequence is aborted and must be
started from the beginning.
Note: If any button other than the next appropriate
button in the sequence is pressed the sequence is
aborted.
Note: If the Start button is not pressed within
25 seconds after pressing the Rotate Right button,
or any other button is pressed in this period, the
Engine Start Enable Condition expires
Note: Engine Start Enable Condition persists for
25 seconds after pressing the Rotate Right button
allowing momentary activation of Engine Start by
pressing the Start button. Pressing the Start button
does not extend this time period—the maximum
15
G020713
Figure 14
3. Hour meter
2
3

Advertisement

Table of Contents
loading

Table of Contents