Checking The Torque Of The Wheel Lug Nuts; Starting And Shutting Off The Engine - Toro Pro Force 44553 Operator's Manual

Checking the Torque of the
Wheel Lug Nuts
Service Interval: After the first 10 hours
Check the torque of the wheel lug nuts initially and
after the first 10 hours of operation.
WARNING
Failure to maintain the proper torque could
result in failure or loss of the wheel, and could
result in personal injury.
Torque the wheel lug nuts to 95 to 122 N∙m
(70 to 90 ft-lb).
Starting and Shutting Off
the Engine
Starting the Engine
WARNING
Rotating parts can cause serious personal
injury.
• Keep hands and feet away from the
machine when it is running.
• Keep hands, feet, hair, and clothing away
from all moving parts to prevent injury.
• Never operate the machine with covers,
shrouds, or guards removed.
Before you start the engine, you must attach the
machine to the towing vehicle.
1. Move the choke control to the O
starting a cold engine.
Note:
A warm or hot engine may not require
choking. After the engine starts, move the choke
control to the O
FF
2. Rotate the engine ignition key to the S
position (Figure 14).
Note:
If the key was left in the R
for an extended time, move the key to the
O position before proceeding to the starting
FF
procedure.
position before
N
position.
TART
position
UN
1. Choke control
2. Hour meter
3. Engine Start will only become energized by
pressing the Start button while the Engine Start
Enable Condition is active. The Engine Start
Enable Condition becomes active only when the
following Engine Start Enable Sequence has
been performed
•
Press the S
•
Then, press the rotate left button.
•
Then, press the rotate right button.
•
Then, press and hold the S
the engine starts.
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start
Note:
There is a time limit of 3 seconds
between each button press. If the next button in
the sequence is not pressed within 3 seconds of
the last button press, the sequence is aborted
and must be started from the beginning.
15
Figure 14
3. Ignition switch
(Figure 15):
button.
TART
button until
TART
Figure 15
5. Rotate right
6. Increase engine speed
7. Engine stop
g029819
g029818