Checking The Torque Of The Wheel Lug Nuts; Starting And Stopping The Engine - Toro Pro Force 44553 Operator's Manual

Checking the Torque of the
Wheel Lug Nuts
Service Interval: After the first 10 hours
Check the torque of the wheel lug nuts initially and after the
first 10 hours of operation.
WARNING
Failure to maintain proper torque could result in
failure or loss of wheel and could result in personal
injury. Torque wheel lug nuts to 95 to 122 N-m (70
to 90 ft-lb)
Starting and Stopping the
Engine
Starting the Engine
WARNING
Rotating parts can cause serious personal injury.
• Keep hands and feet away from the machine
when it is running.
• Keep hands, feet, hair, and clothing away from
all moving parts to prevent injury.
• Never operate the machine with covers, shrouds,
or guards removed.
1. The blower must be attached to the tow vehicle before
it can be started.
2. Move the choke control to the O
starting a cold engine.
Note: A warm or hot engine may not require choking.
After the engine starts, move the choke control to the
O position.
FF
3. Rotate the engine ignition key to the S
(Figure 15).
Note: If the key was left in the R
an extended time, move the key to the O
before proceeding to the starting procedure.
position before
N
position
TART
position for
UN
position
FF
14
Figure 15
1. Choke control
2. Hour meter
4. Engine Start will only become energized by pressing the
Start button while the Engine Start Enable Condition
is active. The Engine Start Enable Condition becomes
active only when the following Engine Start Enable
Sequence has been performed
•
Press the S
TART
•
Then, press the rotate left button.
•
Then, press the rotate right button.
•
Then, press and hold the S
engine starts.
Figure 16
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start
Note: There is a time limit of 3 seconds between each
button press. If the next button in the sequence is
not pressed within 3 seconds of the last button press,
the sequence is aborted and must be started from the
beginning.
Note: If any button other than the next appropriate
button in the sequence is pressed the sequence is
aborted.
3. Ignition switch
(Figure 16):
button.
button until the
TART
5. Rotate right
6. Increase engine speed
7. Engine stop