Table of Contents
Advertisement
Operating
7
Operating
7.1 Operating on the unit
DCL Flat Par 5x4W CW/WW
28
LED PAR
Connect the device to the power supply to start operation. After a few seconds, the display
indicates that a reset is in progress. The device is then ready for use.
Press [Mode] to activate the main menu and select an operating mode. Use [Setup] to select
further options. Use [Up] and [Down] to change the respectively displayed value. When the dis‐
play shows the desired value, press [MODE].
If you do not press any key for about ten seconds, the display will be blanked. It will be reacti‐
vated to display the previously called menu by pressing any button.
The set values are retained even when the device is disconnected from the mains power
supply.
Advertisement
Table of Contents
