Compartments; Electronics Compartment; Figure 2. Pg-Flexplus Field Cabinet Layout (Front View - Shown With Field Cabinet Door Removed) - ADC PG-FlexPlus PG-CAB001 Manual

July 19, 2004
C
OMPARTMENTS
The PG-FlexPlus field cabinet is divided into two compartments
• Upper Electronics Compartment
• Lower Battery Compartment
The upper Electronics Compartment houses the Bulk Power System and all of the active electronic gear. The
Battery Compartment is below the Electronics Compartment and is designed to accommodate various types of
batteries for back-up power. All copper, fiber, and AC power cables enter the field cabinet at the bottom left-side of
the field cabinet. The outside plant copper cable(s) are spliced to the field cabinet cables in the splice chamber.
Splice area
Ground bus
Cable entry
compartment
Figure 2. PG-FlexPlus Field Cabinet Layout (Front View – Shown With Field Cabinet Door Removed)

Electronics Compartment

The PG-FlexPlus field cabinet has a one-sided electronics compartment that includes one 23-inch rack, which
provides 29 inches (737 mm) of vertical mounting space below the 6F-fan unit. Access to the electronics
compartment is obtained by using a special hex key to open the front door of the cabinet
The electronics compartment also contains the Alarm Interface Panel (AIP) and 307 protector block, located to the
left of the rack. The AIP provides an alarm interface and fusing for the field cabinet's fans. The standard layouts of
electronic equipment in each field cabinet are shown in
ADC Telecommunications, Inc.
Alarm
interface
panel
AC
Junction
box
(Figure 2):
Fan Unit
Battery
Compartment
23.0"
(584 mm)
Figure 2.
SCP-PGCAB001-010-01H
29.0"
(737 mm)
(Figure 2).
3