Rotisserie Spit - Bosch HGVDF0V50S Instruction Manual

Operating the appliance
en
Do not press the ignitor for longer than 15 seconds. If
the burner does not ignite within 15 seconds, wait at
least one minute before repeating the procedure.
In the event of the burner flames being accidentally
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one minute.
If the flame goes out
Switch off the control knob. Wait one minute and switch
the burner on again.
:
Warning – Risk of fire!
If the flame goes out, gas will escape. Never leave the
gas burner unattended during operation. Ensure that
there are no draughts.
Switching off the grill
Turn the control knob to the

Rotisserie spit

T he rotary spit is particularly good for cooking large
R o t i s s e r i e s p i t
roasts, such as rolled roasting joints or poultry. The
meat becomes crispy and brown.
Preparing roasts
To ensure that the roast is well-browned and cooked
evenly, observe the following points:
Skewering and securing the meat to the spit
Place the joint as close as possible to the centre of the
rotary spit.
Use the clamps to secure the joint at both ends. In
doing so, the joint must be at least 10 cm away from
the end of the spit.
You can also truss the joint with string. With poultry,
bind the ends of the wings underneath the back and the
thighs against the body. This prevents them from
overbrowning. Pierce the skin on the underside of the
wings to allow the fat to escape.
Inserting the rotary spit
:
Warning – Risk of burns!
Never touch the hot surfaces of the cooking
compartment or the heating elements. Keep children at
a safe distance. Open the appliance door carefully. Hot
steam may escape from the appliance.
:
Warning – Caution!
Do not insert the rotary spit without meat.
Place the rotary spit support on the baking tray. (Fig.
1.
A)
20
position.
Û
Slide the handle onto the rotary spit and screw it on.
2.
Slide the baking tray in at shelf position 1.
3.
Insert the rotary spit onto the support. There is an
4.
opening in the back oven wall. Insert the rotary spit
here. (Fig. B) Ensure that the rotary spit is inserted
correctly.
Remove the handle and close the oven door. (Fig.
5.
C)
Switching on the rotary spit
When using the rotisserie spit, heat the oven
Note:
using the heating mode. Insert the rotisserie spit
(
before setting the heating mode.
F
Turn the control knob for the oven to the
1.
Set the temperature.
2.
Add some water to the universal pan to catch any
Note:
fat that drips out.
Removing the rotary spit
:
Warning – Risk of scalding!
Never touch the hot surfaces of the cooking
compartment or the heating elements. Keep children
away from the appliance at all times. Open the
appliance door carefully. Hot steam may escape from
the appliance.
:
Warning – Risk of scalding!
Never touch the rotary spit or other accessories directly
when they are hot. Always use a pot holder or wear
oven gloves to handle accessories when they are hot.
When the dish has finished cooking, switch off the
1.
selector for the grill and rotary spit grilling.
Open the appliance door carefully.
2.
Slide the handle onto the rotary spit and screw it on.
3.
Pull out the rotary spit carefully from the installation
4.
location.
Remove the baking tray.
5.
position.
F