Spare Parts; Decommissioning; Disassembly And Replacement; Preparing The Product For Storage/Later Use - Bosch rexroth BS 2/C Series Assembly Instructions Manual

10.5 Spare parts

For a list of spare parts, see spare parts list in MTpro, 3 842 539 057
(download: www.boschrexroth.com/mtpro).

11 Decommissioning

This product is a component which does not need to be decommissioned.
Accordingly, this section has been left blank.

12 Disassembly and replacement

High electrical voltage!

Risk of severe injury or death from electric shock.

Disconnect the relevant system component before performing any maintenance
or repair work.

Secure the system against being unintentionally switched on again.
High pneumatic pressure!

Risk of severe injury or death.

Switch off the compressed air supply to the relevant system component before
performing any maintenance or repair work.

Secure the system against being unintentionally switched on again.
Suspended loads may fall!

Falling objects can result in severe injury (or even death).

Use only slings with suffi ciently high bearing loads
(for product weight see delivery documents).

Make sure the lifting straps are correctly fastened before lifting the product!

Secure the product against tipping over when lifting!

Make sure that no one but the operator is in the danger zone during lifting
and lowering!

12.1 Preparing the product for storage/later use

• Only set the product down on a fl at surface.
• Protect the product from mechanical stress.
• Protect the product from environmental infl uences, such as dirt and moisture.
• Observe the ambient conditions, see page 83.
• For belt sections with mounted motor and/or mounted lubrication unit:
Support the belt section so that the motor or lubrication unit are not overloaded.
WARNING
3 842 563 834/2022-08, MIT: BS 2/C-..., BS 2/R-..., Bosch Rexroth AG
Decommissioning 81/84