Required Accessories - Bosch rexroth BS 2/C Series Assembly Instructions Manual

7.4 Required accessories

• Leg set for holding up the belt section.
Please note: Support the belt section in the immediate vicinity of the drive and
return unit. The maximum distance permitted between two leg sets is 2000 mm.
– For BS 2/C-100, BS 2/C-250, BS 2/R-300,
BS 4/R-300, BS 2/R-700, BS 4/R-700:
SZ 2, 3 842 996 320
SZ 2/U, 3 842 996 322
SZ 2/T, 3 842 996 324
– For BS 2/C-H, BS 2/R-H, BS 2/R-V:
SZ 2-H, 3 842 996 321
SZ 2/U-H, 3 842 996 323
SZ 2/T-H, 3 842 996 325
– For fastening the leg sets on the ground, you need the following for each
connection:
– 1x foundation bracket, 3 842 146 815
– 1x dowel, 3 842 526 560
– 2x T-bolt, 3 842 528 718
– 2x fl ange nut, 3 842 345 081
• Connection kit for transverse conveying, for utilization of the belt section in lateral
transverse conveying (drive head-at-section).
– BS 2/C-100, BS 2/C-250, BS 2/R-300,
BS 4/R-300, BS 2/R-700, BS 4/R-700 with:
ST 2/B, ST 2/B-100, ST 2/C-100, ST 2/R-100, 3 842 528 192
– BS 2/C-400, BS 2/C-700, BS 2/R-1200, BS 2/R-2200 with:
ST 2/B, ST 2/B-100, ST 2/C-100, ST 2/R-100, 3 842 518 828
– BS 2/C-H, BS 2/R-H, BS 2/R-V with:
ST 2/C-H, ST 2/R-H, ST 2/R-V, 3 842 528 192
• Connection kit for longitudinal conveyor (drive head at return unit)
– BS 2/C-100, BS 2/C-250, BS 2/R-300,
BS 4/R-300, BS 2/R-700, BS 4/R-700 with:
BS 2/C-100, BS 2/C-250, BS 2/R-300,
BS 4/R-300, BS 2/R-700, BS 4/R-700, 3 842 529 881
– BS 2/C-400, BS 2/C-700, BS 2/R-1200, BS 2/R-2200
BS 2/C-H, BS 2/R-H, BS 2/R-V with:
BS 2/C-100, BS 2/C-250, BS 2/R-300,
BS 4/R-300, BS 2/R-700, BS 4/R-700
BS 2/C-400, BS 2/C-700, BS 2/R-1200, BS 2/R-2200
BS 2/C-H, BS 2/R-H, BS 2/R-V, 3 842 530 871
3 842 563 834/2022-08, MIT: BS 2/C-..., BS 2/R-..., Bosch Rexroth AG
Assembly 17/84