Argo APOLLO Manual page 15

7. Removing the refrigerant circuit
Remove the three screws that connect the end plates on both sides of the
condenser and the base.
1. Unscrew the three nuts that fix the compressor feet respectively, remove the
nuts and gaskets and lift the refrigerant circuit consisting of the compressor,
condenser and evaporator to disengage from the frame assembly (note that the
protection pipe must not be broken)
8. Removing the water pump switch and motor
1. Remove the 2 screws that fix the switch and the 2 screws that fix the water
pump motor.
13