CONTENTS NAME OF PARTS AND OPERATION SELECTOR SWITCH INSTALLATION LOCATION ELECTRICAL REQUIREMENTS SAFETY INSTRUCTIONS USING THE REMOTE CONTROL UNIT REMOTE CONTROL UNIT HOW TO SET THE PRESENT TIME COOLING HEATING AUTOMATIC OPERATION DEHUMIDIFYING (DRY) FAN ONLY ADJUSTING THE FAN SPEED SLEEP MODE SETTING THE TIMER ADJUSTING THE AIR FLOW DIRECTION...
NAME OF PARTS AND OPERATION SELECTOR SWITCH INDOOR UNIT OUT DOOR UNIT COOL MODE lamp INDOOR UNIT RESET button (Press to turn off the filter lamp and cancel the buzzer announcer) HEAT MODE lamp STANDBY lamp OPERATION lamp TIMER lamp FILTER lamp 1.
ELETRICAL REQUIREMENTS WARNING Before installation, check that the voltage of the electric supply The OFF position does not disconnect the power. Use the in your home or office is the same as the voltage shown on the main power switch to turn off power completely. nameplate.
OPERATION WITH THE REMOTE CONTROL UNIT USING THE REMOTE CONTROL UNIT HOW TO INSTALL BATTERIES CAUTION Remove the lid in the rear part of the remote control unit. Insert two AAA alkaline batteries of 1,5 V-DC. Make sure the batteries point in the direction marked in the Check that the circuit breaker on the power panel is turned ON and the the STANDBY lamp is light up.
REMOTE CONTROL UNIT SENSOR DISPLAY TEMPERATURE SETTING BUTTONS Information are displayed when the remote control unit is switched on. A temperature — (cooler) sensor inside the remote control unit Press this button to decrease the set temperature. Operation Mode detects the room Automatic + (warmer) temperature.
HOW TO SET THE PRESENT TIME DEFROSTING OF HEAT EXCHANGER OUTDOOR UNIT “STANDBY” Press the SET button for five seconds. The time indication When the outdoor temperature is low, frost or ice may appear on alone flashes. the heat exchanger coil, reducing the heating performance. When this happens, a microcomputer defrosting system operates.
NOTE NOTE The air conditioner changes the operation mode (from cool to heat The above mentioned data make reference to the conditioner or vice versa, if one of the following conditions occurs: operating when the sensor on the remote control unit is ON. (Refer - ZONE A: changes if the difference between the room temperature to temperature sensor selector).
SETTING THE TIMER ADJUSTING THE AIR FLOW DIRECTION A) HOW TO SET THE OFF TIME HORIZONTAL (manual) 1. Press the ON/OFF button to start the air The horizontal air flow can be adjusted by moving the vertical vanes to the left or right, as indicated in the following figures. conditioner.
OPERATION WITHOUT THE REMOTE CONTROL UNIT If you have lost the remote control unit or it has troubles, follow the steps below. 1. WHEN THE AIR CONDITIONER IS STOPPED If you want to turn on the air conditioner push the MODE button with a pen to select the desired mode (COOL or HEAT).
AIR FILTER TROUBLESHOOTING The filter behind the air intake grille should be checked and cleaned when the filter lamp lights up (see page 3). WARNING HOW TO REMOVE THE FILTER The use of portable telephones near the air-conditioner may cause disturbance to its normal operation and must be avoided.
Page 12
Via Varese, 90 - 21013 Gallarate - Va - Italy Tel. +39 0331 755111 - Fax +39 0331 776240 www.argoclima.it Part No:4527348/01...
Need help?
Do you have a question about the AW22AL and is the answer not in the manual?
Questions and answers