Programming Macros - JBL CINEMA PROPACK 600 Owner's Manual

Remote Control Functions
(Continued)

Programming Macros

Macros enable you to easily repeat frequently
used combinations of commands with the press
of a single button on the remote control. Once
programmed, a macro will send out up to 19
different remote codes in a predetermined
sequential order, enabling you to automate the
process of turning on your system, changing
devices, or other common tasks. The remote can
store up to three separate macro command
sequences: one that is associated with the Power
On Button , and two more that are
accessed by pressing the Macro Buttons
.
The DCR600 remote also features two pre-
programmed functions, ALL OFF
ON , that turn all eight programmed devices
off or on when the appropriate key is pressed.
1. Press the Mute Button
Buttons to be programmed or the
Power On Button
Note that an Input Selector
will light red, and the Program Indicator
will flash.
2. Enter the steps for the macro sequence by
pressing the button for the actual command
step. Although the macro may contain up to
19 steps, each button press, including those
used to change devices, counts as a step.
The Program Indicator will flash to confirm
each button press as you enter commands.
NOTE: While entering commands for Power
On/Off of any device during a macro sequence,
press the Mute Button
actual Power button.
3. When all the steps have been entered,
press the Sleep Button
commands. The red light under the Input
Selectors , –
turn off.
Example: To program the Macro 1 button so
that it turns on only the DCR600, TV and a
Cable Box, follow these steps:
• Press the Macro 1
buttons at the same time and then
release them.
• Note that the Program Indicator will
flash.
• Press the MAIN Selector
and ALL
and the Macro
at the same time.
, –
. DO NOT press the
to enter the
will blink and then
and Mute
.
43