Table of Contents
Advertisement
3. If the Connection Status indicator in the
lower left corner of the screen indicates
there is no ECU Connection even though
the CAN Hardware is connected (Figure 3):
A. Close the FST program per the Close
the FST Program" section in this
chapter then start to FST program per
the "Start the FST Program" previously
in this chapter.
NOTICE: If neither of the status lights are
lit:
Examine the cable and connection
(1)
between the CAN Adapter and the
ECU to make sure the connections are
secure, and the cable is not damaged.
Replace damaged cables or cables with
(2)
damaged connectors.
Attach the cable per the "ECU to FST
(3)
Connection" Chapter in this manual.
Start to FST program per the "Start the
(4)
FST Program".
4. If the engine serial number displayed by
the FST is not the same as the serial
number on the engine data tag:
A. Click the Edit Engine S/N (Figure 4)
button on the "Engine Serial Number"
panel.
B. Enter the correct engine serial number
in the "New Serial Number" box of the
"Prompt User for Input" window.
C. Click OK then click Upload on the
"Engine Serial Number" panel.
5. If the engine hours displayed by the FST is
not correct:
A. Click the Edit Engine Hours (Figure
5) button on the "Engine Serial
Number" panel.
B. Enter the correct engine serial number
in the "New Engine Hours" box of the
"Prompt User for Input" window.
C. Click OK then click Upload on the
"New Engine Hours" panel.
Access the Field Service Tool
Page 16
Field Service Tool User Manual
TEO-540-C1A Engine Maintenance Manual
Figure 3
ECU Not Connected
Figure 4
New Serial Number Window
Figure 5
Engine Hours Update
© 2022 Avco Corporation. All Rights Reserved
August 2022
Advertisement
Table of Contents
