UV MEDICO UV222 Installation Manual page 19

If the information programmed into the UV222 when installed is different than the use/
occupancy of the room, UV Medico A/S cannot be held liable for any injuries or misuse of
these units.
If the room changes of use, occupancy or any change that has an influence on the risks of
exposure, the installer needs to be contacted so the Product is reprogrammed.
11) Testing the Product.
Right click on the photo of the UV222
Here you can quickly light up the UV222 and test the signal LED.
When you press "On"
safety! This is only to test the source, (the box "Enable" will be automatically ticked)
When you go to LED Mode you have 3 possibilies to choose:
"Normal Mode" Work as UV222 is programmed.
"Led Off" Turns the LED off.
"Led RGBW Off" LED test cycle.
When you untick the "Enable" box it goes back to normal configuration/use.
B
C
at 222 LightSource section, it will turn on the UV222 with no
and a pop up of the test mode will show up.
C
B
19