Replacing The Audio In Connector - Sony HDC-900 Maintenance Manual

3-12. Replacing the MIC Connector

3-12-2. Replacing the AUDIO IN Connector

1. Loosen six screws, and pull out MIC panel assembly.
n
When pulling out a MIC panel assembly, pay full
attention to the harnesses and or flexible card wires
connected to the MIC panel assembly so that they are
free from incurring any damages.
2. Disconnect the harness connectors from the connectors
(CN2, CN5) of CN-1951 board and from CN-2063
connector (CN4). Also, disconnect a flexible card wire
from the connector (CN6) of CN-1951 board.
n
Refer to Section 1-6 for details on disconnecting/
connecting the flexible card wire.
CN4
( CN-2063 board )
CN3
( CN-1955 board )
Precision
P2.6 x 8
3-16 (E)
Harness connector
CN5
( CN-1951 board )
Precision
P2.6 x 8
(with stopper)
CN6
( CN-1951 board )
CN2
( CN-1951 board )
MIC panel assembly
3. Remove the 4 screws first, and remove the AUDIO IN
connector, pressing connector lever.
AUDIO IN connector
MIC panel assembly
4. Install the new AUDIO IN connector in the reverse
order of steps 1 to 4.
Levers
Precision
P2.6 x 5
HDC-900/950 MM