Replacement Of Main Parts (Hdc-950); Replacing The Ccd Unit - Sony HDC-900 Maintenance Manual

3-1. Replacing the CCD Unit

n
Never remove or install the CCD unit with the power
turned on. Because touching internal harness to the cabinet
or other printed circuit boards during replacement causes
shorts or electric hazards.
Prior to replacement, be sure to disconnect the optical
cable or the cable connected at the DC IN connector in
addition to turning off power switch.
1. Remove the inside panel and outside panel. (Refer to
Section 1-4 of the Installation and Maintenance
Manual.)
2. Loosen the four screws of front assembly, and remove
the front assembly.
B3 x 10
(with stopper)
B3 x 10
(with stopper)
Front assembly
HDC-900/950 MM
Section 3

Replacement of Main Parts (HDC-950)

3. Remove the four hexagon-socket bolts, remove the
four spring washers, and remove the front panel
assembly.
Spring
washers
Hexagon-socket bolts
(3 x 8)
4. Disconnect the harness connector from the connector
of CCD unit, loosen the two fixing screws of the filter
disk unit, and remove the filter disk unit.
Connector
Fixing screw of the filter
disk unit (with stopper)
Front panel assembly
Fixing screw of the filter
disk unit (with stopper)
Filter disk unit
Harness connector
3-1 (E)