Setting The Rtc - Sony HDC-900 Maintenance Manual

5-4. Manual RPN Correction

5-5. Setting the RTC

6. Temporary concealment is executed and the concealment determination page (CONCEALMENT?)
will be displayed as shown below.
After RPN disappears, move the "→" to "OK" and press the rotary encoder.
n
If "OK" is executed other than the RPN position, the erroneous data is stored. This erroneous data
alone cannot be deleted.
Before pressing the rotary encoder
RPN concealment will be executed, and the PIXEL page will automatically be returned.
If RPN still appears, move the "→" to "CANCEL", press the rotary encoder
CONCEALMENT?
CANCEL
OK
Concealment determination page
7. Set the "DETAIL" of the SW STATUS page in the PAINT menu to "ON".
(Refer to Section 3-4 of the Installation and Maintenance Manual.)
*1 : For HDC-950
HDC-900 : Press the MENU SELECT switch toward the "ENTER" side.
5-5. Setting the RTC
If the lithium battery mounted on the AT-130 board has been replaced, set the RTC.
1. Display the RTC page of the SERVICE menu. (Refer to 5-3.)
2. Adjust the "→" to the RESET RTC, and press the rotary encoder.
The calendar is reset to 2000 (year), 01 (month), 01 (day), 00 (hour), 00 (minutes), 00 (seconds).
3. Rotate the rotary encoder
*1 : For HDC-950
HDC-900 : Press the MENU SELECT switch toward the "ENTER" side.
*2 : For HDC-950
HDC-900 : Rotate the MENU SELECT control.
5-8 (E)
*1
, be sure to check the RPN is disappeared.
*2 , and set the year, month, day, hour, minutes, and seconds.
*1
*1 and repeat from step 4.
*1
HDC-900/950 MM