Replacing The Filter Disk Unit; Filter Disk Unit - Sony HDC-900 Maintenance Manual

2-1. Replacing the CCD Unit

2-2. Replacing the Filter Disk Unit

6. Remove the three screws, and remove the transporta-
tion holder from the CCD unit for repair part HKC-
C900R (optional).
Transportation holder
P3 x 6
P3 x 6
P3 x 6
7. Install the new CCD unit in the reverse order of steps 1
to 6.
[Note|at|installation]
When installing the CCD unit, adjust the boss of the front
assembly to the hole on the chassis and connect the
connector firmly.
Boss
Boss
Front assembly Connector
2-2 (E)
2-2. Replacing the Filter Disk Unit

2-2-1. Filter Disk Unit

1. Open the right side panel. (Refer to Section 1-4 of the
Installation and Maintenance Manual.)
2. Disconnect the harness connector from the connector
of filter disk unit, loosen the two fixing screws of the
filter disk unit, and remove the filter disk unit.
CCD unit
Filter disk unit fixing screw
(With stopper)
Filter disk unit
Filter disk unit fixing screw
(With stopper)
3. Install the new filter disk unit in the reverse order of
steps 1 and 2.
n
At installation, do not touch the surfaces of filters.
Hole
CCD unit
HDC-900/950 MM