Replacement Of Main Parts (Hdc-900); Replacing The Ccd Unit - Sony HDC-900 Maintenance Manual

2-1. Replacing the CCD Unit

n
Never remove or install the CCD unit with the power
turned on. Because touching internal harness to the cabinet
or other printed circuit boards during replacement causes
shorts or electric hazards.
Prior to replacement, be sure to disconnect the optical
cable or the cable connected at the DC IN connector in
addition to turning off power switch.
1. Open the right side panel. (Refer to Section 1-4 of the
Installation and Maintenance Manual.)
2. Loosen the screw of mount lever fixing lid, and open
the mount lever fixing lid in the arrow direction.
3. Loosen the four screws of front assembly, and remove
the front assembly.
Front assembly
PWH4 x 12
(With stopper)
PWH4 x 12
(With stopper)
Mount lever fixing lid
HDC-900/950 MM
Section 2

Replacement of Main Parts (HDC-900)

Screw
4. Remove the four hexagon-socket bolts, remove the
four spring washers, and remove the front panel
assembly.
Spring
washer
Hexagon-socket bolts
(3 x 8)
5. Disconnect the harness connector from the connector
of CCD unit, loosen the two fixing screws of the filter
disk unit, and remove the filter disk unit.
CCD unit
Connector
Filter disk unit fixing screw
(with stopper)
Front panel assembly
Filter disk unit fixing screw
(with stopper)
Filter disk unit
Harness connector
2-1 (E)