Replacing The Side Switches (Sw-1014 Board) - Sony HDC-900 Maintenance Manual

3-5. Replacing the Side Switches
(SW-1014 Board)
1. Remove the front fan assembly.
(Refer to Section 3-4-2.)
2. Open the side switch covers, then removes the two
screws, and remove the side switch panel assembly.
Side switch cover
3. Disconnect the harness connectors from the connectors
(CN1, CN2, and CN3) of SW-1014 board.
4. Remove the tow screws, and remove the side switch
block.
CN1
CN2
HDC-900/950 MM
http://getMANUAL.com
5. Remove the two screws and two blind plates, and
Precision P2.6 x 5
Side switch
panel assembly
6. Install the new switches in the reverse order of steps 1
CN3
Precision
P2.6 x 5
Side switch block

3-5. Replacing the Side Switches (SW-1014 Board)

remove the SW-1014 board. Desolder the switch to be
replaced.
Precision
P2.6 x 5
to 5.
SW-1014 board
Blind plates
3-9 (E)