Tripp Lite SMART600PSGLCD Owner's Manual page 8

5. Installation
Remote panel operation
The LCD panel can be removed from the base and placed in a location that is easier to view. Follow the steps below to remove
the remote panel. The distance between the remote panel and the base cannot exceed 20 ft. (6 m).
An NiMH battery is installed on the back of remote panel. Once the remote panel is installed on the base unit, it charges the
battery automatically. When the battery capacity is low, the
6. Battery Replacement
Under normal conditions, the original battery in your UPS will last several years. Battery replacement should only be performed
by qualified service personnel. Refer to Battery Warnings in section 1. Important Safety Instructions for complete safety
information.
• WARNING! This UPS contains potentially hazardous voltages. Do not attempt to disassemble the UPS beyond the battery
replacement procedure.
• This UPS contains no user serviceable parts. Repairs and battery replacement must be performed by QUALIFIED SERVICE
PERSONNEL ONLY.
• Caution - Do not dispose of batteries in a fire. The batteries may explode.
• Caution - Do not open or mutilate batteries. Released electrolyte is harmful to the skin and eyes. It may be toxic.
• Caution - A battery can present a risk of electrical shock and high short-circuit current. Contact with any part of a grounded
battery can result in electrical shock. The following precautions should be observed when working on batteries:
1. Remove watches, rings or other metal objects.
2. Use tools with insulated handles.
3. Wear rubber gloves and boots.
4. Do not lay tools or metal parts on top of batteries.
5. Disconnect the charging source and load prior to installing or maintaining the battery.
6. Remove battery grounds during installation and maintenance to reduce the likelihood of shock. Remove the connection
from ground if any part of the battery is determined to be grounded.
• Caution - risk of electric shock. The battery circuit is not isolated from the input voltage. Hazardous voltages may occur
between the battery terminals and the ground. Before touching, verify that no voltage is present.
• Replace the fuse or circuit breaker only with the same type and amperage in order to avoid fire hazards.
• Only persons adequately familiar with batteries and the required precautionary measures may replace batteries and
supervise operations. Unauthorized persons must keep away from the batteries.
• Caution - Replace batteries with the same number and type as originally installed in the UPS. These batteries have
pressure-operated vents. The UPS system contains sealed, non-spillable maintenance-free lead acid batteries.
icon flashes to remind you to charge the remote panel.
8