Tripp Lite SMART600PSGLCD Owner's Manual page 11

8. Operation
Button Functions
Button Function
On/Off • Press and hold 2 seconds to turn the UPS on or off.
• Holding the "On/Off" button for 10 seconds can reset the unit in the event of communication failure between
remote panel and UPS.
• Quick-press the button 5 times to reset pairing when wireless transmission fails.
• In Menu Mode, the On/Off button is used to select a sub-menu or approve the selection of a setting.
Mute • Press and hold 2 seconds to enable or disable mute function.
• A quick press of the mute button will return to the main screen or exit the setting programs.
Up/Down • Press and hold 2 seconds to enter the setting menu.
• A quick press will switch display information.
Audible Alarms
Overload
Low Battery
Overcharge
Battery Replacement
Battery Mode
Fault
LCD Panel
Operating Mode Display Icons
AC MODE
BATTERY MODE
Additional UPS Status Icons
UPS FAULT +
Error Code
ALARM MUTE /
DISABLE
Sounds every 0.5 seconds.
Sounds every second.
Sounds every 1.5 seconds.
Sounds every 2 seconds.
Sounds every 10 seconds.
Sounds continuously.
The AC MODE icon indicates the UPS is:
• RECEIVING acceptable AC utility input voltage.
• PROVIDING conditioned UPS output to connected equipment.
• READY to switch to battery mode in the case of power failure.
• CHARGING internal batteries as necessary to maintain full battery
charge.
The BATTERY MODE icon indicates the UPS is:
• RUNNING IN BATTERY BACKUP MODE and providing inverter-derived
AC sine wave output to connected equipment using battery reserves.
• NOT RECEIVING acceptable AC utility input voltage.
The UPS FAULT icon indicates the UPS is experiencing the fault
condition indicated by the on-screen ERROR CODE.
Some faults may cause UPS shutdown, depending on the severity of the
fault condition encountered. A list of reported fault-codes are shown in
section 9. Troubleshooting of this manual.
The ALARM MUTE icon indicates the UPS alarm has been silenced
during Battery mode operation.
To set the ALARM MUTE function, press and hold the alarm-cancel button
for approximately 2 seconds as the alarm is sounding.
11