Tripp Lite SMART600PSGLCD Owner's Manual page 15

8. Operation
UPS Set-Up & LED Programming Mode
UPS Set-Up / Programming mode contains 13 screens of user-selectable UPS and LED programming options. Each of the
programming options are designated on-screen as items P1 through P13 (SMART1500PSGLCD offers a P14 option).
To enter UPS Set-up mode:
• Press and hold the UP/DOWN button for two seconds.
• The UPS will enter Set-up mode and display program P1 on the LCD screen.
• Press the UP/DOWN button repeatedly advance to other program options (P1, P2, P3, etc.).
To edit individual programming options:
• Advance the screen to the program to be edited (P1, P2, P3, etc.).
• Press the POWER button to ENTER SELECTABLE OPTIONS.
• Press the POWER button again to VIEW SELECTION OPTIONS (the first selectable option will flash).
• Press the UP/DOWN button repeatedly to scroll through available selection options (the option selected will be flashing).
• Once the desired selectable option is flashing, press the POWER button again to SELECT it (the selected option will stop
flashing and the program will immediately go into effect).
LED configuration options are fully available via the front panel LCD screen. Users may find it easier to configure LED effects
using Tripp Lite's LED configuration software available for download at this link: tripplite.com/products/management-utilities.
Program Description
On-Off RGB LED LED off
Front Bank
Energy saving
On-Off RGB LED LED off
Bottom Bank
Energy saving
Brightness of RGB Low
LED Front Bank
High (default)
15
Selectable option
LED on (default)
LED on (default)
Normal