Set-Up View; Demo Program, Display Contrast; Units Of Measure - Interphase Proble Operation Manual

Set-Up View

The Probe includes a SET-UP View where the DEMO
program can be activated, the units of measure and
language can be selected. The display contrast can be
adjusted by turning the front panel rotating knob. The
Probe s internal backup battery will remember all settings
for future use.
From the Control Center press the button below the
SET-UP soft key twice to put the display into the SET-
UP View. Then press the button below the "GO" soft key
to use this view. The display should appear as on the
right.
Demo Program
We highly recommend you initially operate the Probe in
the DEMO mode to familiarize yourself with the many
advanced features of the Probe. When using the SET-UP
view, press and hold the soft key below DEMO until the
unit beeps twice and the word "DEMO" on the display
changes to reverse video as shown at left. This will
activate the simulation program. The unit will
automatically cycle through a simulated demonstration of
its many features. At any time, you can press any key to
gain control of the DEMO program to make your own
selections and adjustments. If you do not press any button
for about 45 seconds, the unit will automatically resume
cycling through the different demo features on its own.
The pictures shown in the DEMO mode are
representations of what you might see on your Probe. In
actual use the picture you will get can vary significantly
depending on depth, bottom and water conditions, the
speed of your boat and many other factors (see
Interpreting The Probe's Forward Display, page 44).
To exit the DEMO program either turn the Probe off and
back on again, or press the "DEMO" soft key again.
Select Units of Measure
The Probe starts with the last units of measure selected.
By pressing the button indicated on the display, you can
use the large front panel knob labeled "BEAM" to choose
between U.S., Nautical and Metric units. Rotate the front
panel knob to select (highlight) the type of display units
s
desired. Once elected, press any button to save your
selection and exit. The current choice is displayed each
time the "UNITS" soft key is pressed.
24