Table of Contents
Advertisement
150-450-141-02, Issue 2
4
Do one of the following:
–
If the installation location is wood, use a drill with a wood or metal drill bit to drill the mounting screw
holes into the wooden surface.
–
If the installation location is concrete, use a drill with a concrete drill bit that is slightly smaller than the
diameter of the anchor nuts to drill the mounting screw holes into the concrete surface.
5
Insert the two anchor nuts into the mounting screw holes and tap the nuts into place with a hammer.
6
While holding the HRE-450 List 4A in place, place a washer over one of the mounting screw holes and, using
a #2 screwdriver, screw one of the provided wood screws into the mounting hole.
7
While holding the HRE-450 List 4A in place, place a washer over the other mounting screw hole and, using
a #2 screwdriver, screw another of the provided screws into the mounting screw hole.
HRE-450 List 4A
ADC
HRE 450
TELEPHONE COMPANY PROPERTY
Figure 5. Locating the Mounting Screw Guides
August 18, 1998
Mounting screw guides
Installation
7
Advertisement
Table of Contents
