Intermec SR30 User Manual page 14

Chapter 1 — Learning About the SR30
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on your SR30. Use
EasySet version 5.4.4.0 or later to enable and disable symbologies
for your scanner. EasySet is available on the CD that ships with
the SR30 or from the Intermec web site at www.intermec.com.
To scan a bar code
1 Point the scanner window at the bar code label and hold the
SR30 steady about an arm's length from the label.
A ABCD ABCD
2 Pull the trigger and direct the red beam so that it falls across
all bars in the bar code label.
Use this test bar code:
Code 39 Test Bar Code
*123456*
*123456*
Tip: Depending on your screen resolution, you may be able
to scan bar codes displayed on your computer screen.
When the SR30 successfully reads a bar code label, the SR30
creates a single beep and the status light briefly turns green.
3 Release the trigger.
4
Status
light
SR30 Handheld Scanner User's Guide