Resetting The Sr30 - Intermec SR30 User Manual

Chapter 3 — Troubleshooting and Maintaining the SR30
Problems and Possible Solutions (continued)
Problem
You scan a bar code, the
SR30 beeps once, and the
status light blinks green
two times, but the data is
not transmitted to the host
device.
You scan a configuration
bar code and the SR30
beeps three times.

Resetting the SR30

If your SR30 does not respond when you pull the trigger, you can
reset your SR30. When you reset your SR30, the scanner control
firmware is restarted.
To reset your SR30
• Scan this bar code.
Reset factory defaults
18
Possible Solution
Try these possible solutions:
• Make sure that the accessory cable is
properly plugged in to the SR30 and
host device.
• Make sure that your data collection
application is set up to receive data
from the SR30.
• If you are using an RS-232 cable, make
sure that the serial parameters on the
SR30 match the serial parameters of
the host device. The default serial
parameters for the SR30 are: 19200
baud, 8 data bits, no parity, and 1 stop
bit.
Note: You can use EasySet version 5.4.4.0
or later to connect to your SR30 and test
the serial connection. For help, see the
EasySet software.
The SR30 does not recognize or support
the configuration bar code you scanned.
SR30 Handheld Scanner User's Guide