Clarion VRX 835 VRX835 VRX835 Owners & Installation Manual page 46

I Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-installed
radio, install the main unit with the parts and
screws marked (∗). (Figure 8)
If the vehicle is not equipped with a factory-in-
stalled radio, obtain an installation kit to install
the main unit in the following procedure.
1. Remove the screws from both side of the
main unit. Then, at either side, lift the leaf
spring until the engaging claws are released
from the holes, and slide the spring to the di-
4-Hexagonal screw ∗ (M5 × 8)
Centre Panel (Note 1)
∗: The screws with this mark
are enclosed in this set.
#: The parts and screws with this mark
are used to install radio or included in
the installation kit.
Note 1: In some cases, the centre panel may re-
quire some modification (trimming, filling,
etc.).
50
VRX835
2-Screw
Main Unit
2-Spring
Screwdriver
Figure 7
Mounting bracket #
(1 pair for the left and right sides)
Figure 8
rection of arrow to remove it. Repeat the
same for the other side to remove the
springs from the both sides. (Figure 7)
2. Secure the mounting brackets to the chassis
as shown in Figure 8. Holes are pre-tapped for
TOYOTA and NISSAN vehicles; modification,
such as drilling new holes, of the mounting
brackets may be required for other models.
3. Wire as shown in Section 8.
4. Secure the unit in the dashboard, and then
reassemble the dashboard and the centre
panel.
Main Unit
Pocket
Note 2
Note 2: If a hook on the installation bracket inter-
feres with the unit, bend and flatten it with
a nipper or a similar tool.
Engagin claw