Clarion VRX 835 VRX835 VRX835 Owners & Installation Manual page 36

DSP operations
Calling P.EQ BASIC Pattern/USER
Pattern
1. Press the [A-M] button to show the AUDIO-
MODE display.
2. Touch the [z] key to select "P.EQ BASIC"
and "P.EQ USER" mode.
Touch the [P.EQ BASIC] and [P.EQ USER]
key to show BASIC pattern selecting display
or USER pattern selection/memory display.
3. In the pattern selecting display, touch the one
of pattern key to call corresponding P.EQ
pattern. In this display, pressing the No. but-
ton in corresponding to the [DIRECT] key
can also call the P.EQ pattern.
∗ After selecting the P.EQ Pattern, touch the
[MEMO] key to copy the select pattern to the
USER pattern.
∗ Touch the [EDIT] key to show P.EQ adjusting
display, in which the properties of currently
selected pattern can be adjusted.
∗ By pressing the [BAND] button in BASIC
pattern selecting display or USER pattern
selection/memory display you can switch
between the two patterns, BASIC and USER.
4. After the selecting, press the [A-M] button
again or touch the [RTN] key two times to re-
turn to the STANDARD display.
Setting and storing P.EQ Properties/
Memory into USER Pattern
1. In the Basic adjustment display or in the
User setting display, press the [A-M] button
to show the AUDIO-MODE display.
2. Touch the [EDIT] key to show the P.EQ ad-
justing display.
3. Select an item to be adjusted by touching
[ITEM] key in the P.EQ adjusting display.
4. Touch the [ITEM] key to set each adjusting
value.
The P.EQ adjustment contents are as fol-
lows:
G"FRONT/REAR"
G"BAND"
Select the channel to be compensated (front
or rear).
G"FREQUENCY"
Select the center frequency that you want to
compensate from the range of 20 Hz to 20
kHz. (1/3 octave step, 31 points)
40
VRX835
G"GAIN"
Adjust the gain (output level) in the range of -
12 dB to +12 dB. (1 dB step, 25 points)
G"Q"
Set the sharpness of the Q-curve to one of
the parameters: 1, 3, 5, 7 and 20.
5. After making adjustments to a desired pat-
tern by repeating the operations of items 3
and 4, touch the [RTN] key to change over to
the BASIC/USER pattern selection/memory
display.
6. Press and hold one of [DIRECT] button for 2
seconds or longer to store the adjusted P.EQ
pattern to the USER memory.
7. To set a title of the stored USER pattern,
touch the [TITLE] key to change into the
[TITLE INPUT] key.
∗ For title inputting method, refer to the section
"Entering titles".
8. Press the [A-M] button to change into the
STANDARD display.