Decode; Scanning Sequence; Send No-Decode Characters; Bi-Directional Redundancy - Intermec SE1022 User Manual

S S E E C C T T I I O O N N 2 2 Scanner Parameters
"
The scanner uses a power conservation method that causes it to power
down after 1/2 to 1 second. Because of this, bar codes in a multiple bar
code parameter sequence must be scanned within 1/2 second of each
other.
"
NOTE:
Tip: After reading a bar code, aim the scanner away from the bar codes and
press the SCAN key within 1/2 second, to get the laser beam back on. While
the laser beam is on, you have five seconds to find and scan the next bar code.
E E r r r r o o r r s s W
Should you make an error during a scanning sequence, no problem,
simply rescan the correct sequence.
R R e e s s e e t t t t o o D D e e f f a a u u l l t t S S e e t t t t i i n n g g s s
RESET ALL PARAMETERS
TO DEFAULT
Parameter Name

Send No-Decode Characters

Bi-directional Redundancy

Decode Attempt Time

Preamble Character
Postamble Character 1
Postamble Character 2
Code Identification Options
2 2 - - 2 2 SE 1022 User's Guide
W h h i i l l e e S S c c a a n n n n i i n n g g
Table 2-1
S S c c a a n n n n e e r r D D e e f f a a u u l l t t S S e e t t t t i i n n g g s s
Page
Number
Page 2-5
Page 2-5
Page 2-6
Page 2-8
Page 2-8
Page 2-8
Page 2-9
Default Setting
Disabled
Disabled
3.0 Seconds
Disabled
HEX 0D
HEX 0A
No Code ID