Load Paper Into Printer; Adjust The Pinfeed Holders - Intermec PK80 Quick Start Manual

original facing you, and lay the stack flat into the tray. Pull the
top form out to load into the printer.
Load the Dashboard Paper Tray
If your PK80F Printer is attached to a dashboard mount, do the
following to load paper into that tray:
1 With the original facing you, insert a stack of paper inside the
box from the front of the dashboard mount.
2 From the back of the dashboard tray, pull the top form out,
then over the printer into the mechanism.

Load Paper into Printer

Follow these steps to load the paper into the
printer, or paper jams may occur.
Paper for the PK80F Series Printer has perforated strips that fit
onto the pinfeed holder pins, guiding the paper into the printer.

Adjust the Pinfeed Holders

Note: There are two pinfeed holders, one next to the
green thumb wheel and one opposite the same wheel.
Always loosen the pinfeed holder opposite the green
thumb wheel.
Adjusting the pinfeed holder next to the green thumb wheel
may cause information to print in the wrong place. If this
pinfeed holder is moved, correct its location by releasing the
pinfeed holder tab, moving the pinfeed holder as close to the
green thumb wheel as possible, then locking the pinfeed holder
tab, before adjusting the opposite pinfeed holder.
If the paper does not properly fit on the two pinfeed holder fol-
low these steps to adjust the pinfeed holders.
1 With the pinfeed holders open, release the locking tab on the
pinfeed holder opposite the green thumb wheel.
2 Adjust the pinfeed holders to align the pins with the paper.
3 Close the pinfeed holder.
10 PK80F 80-Column Fixed Mount Printer Quick Start Guide