Table of Contents
Advertisement
Media
cover
Latch
assembly
Tear-Off mode
The printer advances the media to the next label if printing
labels. If you are printing on continuous media, the printer will
advance a short strip of media and will then be ready for
printing.
Verifying the Printer Is Working
Before you connect the printer to your computer or portable
data terminal, make sure that the printer is in proper working
order. You can do this by printing a configuration label using
the next procedure. If you cannot get this label to print, see the
EasyCoder PL4 Printer User's Guide.
To print a configuration label
1 Turn the printer off. Load the media compartment with
continuous media (media with no black marks or gaps).
2 While holding the Feed button, press and release the Power
button. When printing starts, release the Feed button.
The printer prints a line of interlocking "x" characters to make
sure all elements of the printhead are working, prints out the
version of software loaded in the printer, and then prints two
reports.
EasyCoder PL3 Printer Quick Start Guide
Media
cover
Latch
assembly
Self-Strip mode
15
Advertisement
Table of Contents
