Optimize Bar Code Magnification
Purpose:
Default:
Optimize Batch
Purpose:
Default:
Optimize Image Magnification
Purpose:
Default:
Paper Type
Purpose:
ZSim Programmer's Guide
This setting compensates for size differences
when a 300 dpi Zebra printer is replaced by an
Intermec printer with a 203 dpi printhead. If
the bar code ends up being too small, increase
the value of this parameter to manually enlarge
the x-dimension. Valid values are 0 to 9.
0 (no magnification)
Note: When replacing a Zebra printer, choose an
Intermec printer with the same printhead
resolution. However, if you are replacing a 152
dpi Zebra printer, use an Intermec printer with a
300 dpi printhead.
To obtain higher performance during batch
printouts.
On
Note: When replacing a printer, choose a printer
with the same printhead resolution. However, if
you are replacing a 152 dpi printer, use an
Intermec printer with a 300 dpi printhead.
If the Intermec printhead is not the same
resolution as the original Zebra printhead,
images may not print correctly. If you want to
increase the size of printed images, you can
adjust this with the function On/Off.
Off
Sets the type of paper used in the printer. You
can set this command to Thermal Transfer or
Direct Thermal. Set this parameter during the
Initial Setup Configuration process.
29