Horizon Fitness TR3.0 Owner's Manual page 8

ASSEMBLY STEP 3
HARDWARE FOR STEP 3
PART TYPE DESCRIPTION
A BOLT M8X1.25PX15L
B SPRING WASHER 8.0X13.0X1.5T
C FLAT WASHER 8.2X13.0X1.4T
A
B C
2
1
14
NOTE: Be careful not to pinch any wires
while assembling the console.
QTY
4
A Pull the LEAD WIRE through the bottom end of
4
the HANDLEBAR.
4
B Open HARDWARE FOR STEP 3.
C Attach the HANDLEBAR to the LEFT CONSOLE
MAST (2) using 2 BOLTS (A), 2 SPRING
WASHERS(B) and 2 FLAT WASHERS (C).
D Do the same above for the another HANDLEBAR.
NOTE: Do not fully tighten bolts until STEP 5.
A B C
ASSEMBLY STEP 4
HARDWARE FOR STEP 4
PART TYPE DESCRIPTION
A BOLT M8X1.25PX15L
B SPRING WASHER 8.0X13.0X1.5T
C FLAT WASHER 8.2X13.0X1.4T
5
A
B C 2
4
1
A Open HARDWARE FOR STEP 4.
QTY B Gently place the CONSOLE (5) on top of the
CONSOLE MASTS (1&2). Attach the LEFT SIDE
6
first using 3 BOLTS (A), 3 SPRING WASHERS (B)
6
and 3 FLAT WASHERS (C).
6
C The CONSOLE CABLES (4) are tucked into
the CONSOLE MAST (2). Using the lead wire
carefully pull the CONSOLE CABLE (4) out of
the CONSOLE MAST (2). Detach and discard the
LEAD WIRE. Connect the CONSOLE CABLES
(4) and carefully tuck wires in the mast to avoid
damage.
D Attach the RIGHT SIDE of the CONSOLE (5) using
3 BOLTS (A), 3 SPRING WASHERS (B) and 3 FLAT
WASHERS (C).
A B C
15