Water Softener Filter; Replacing The Filter; Removing The Filter - DeLonghi MAGNIFICA START ECAM22 2 Series Instructions For Use Manual

Please note:
In energy saving mode, a few seconds may elapse before hot
water emerges as the appliance must heat up.

10. WATER SOFTENER FILTER

To ensure the performance of the machine remains constant
over time, we recommend using a De'Longhi water softener
filter.
For more information, visit the www.delonghi.com website.
To use the filter correctly, follow the instructions below.
1. Remove the filter from the packaging and turn the date
indicator to view the next two months (fig. 18);
2. To activate the filter, run tap water through the hole in the
centre of the filter until water comes out of the openings
at the side for more than a minute (fig. 19);
3. Remove the tank from the machine and fill with water; insert
the filter in the water tank, immersing it completely for about
ten seconds, while tilting it and applying light pressure so that
the air bubbles are able to escape (fig. 20);
4. Insert the filter in the relative housing and press fully
home (fig. 21);
5. Closethe tank with the lid, then reposition the tank in the
machine;
6. Place an empty container of at least 0.5 litres capacity
under the steam/hot water spout (fig. 22).
EAN: 8004399327252
0,5 L
18
20
7. See instructions in section "12. Settings menu" for instal-
lation of the filter;
8. The Led relative to the
rapidly: turn the steam/hot water dial (A19) to the I po-
sition (fig. 12);
9. The appliance delivers hot water, then stops automatically;
10. The Led relative to the
rapidly: turn the steam/hot water dial to the O position;
11. The filter is now active and the machine can be used.
Please note:
If the Led relative to the
press the button. This will cause the internal circuits of the
machine to start filling up, expelling the air bubbles that have
19
been formed and allowing the installation to proceed.

10.1 Replacing the filter

Replace the filter when the
1. Remove the water tank and the spent filter;
2. Follow the operations described in the previous section to
activate the filter;
3. See instructions in section "12. Settings menu" to set the
machine and repeat steps 8 to 11 of the preceding section.
Please note:
After two months (see date indicator) or when the appliance
has not been used for 3 weeks,the filter should be replaced
even if the message has not yet been displayed.

10.2 Removing the filter

To continue using the appliance without the filter, it must be
removed, and the appliance notified of its removal.
1. Remove the water tank and the spent filter;
21
2. See instructions in section "12. Settings menu" to set the
machine.
Please note:
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, the filter should be replaced even if the
message has not yet been displayed.
10
0,5 L
22
Steam button starts flashing
Steam button starts flashing
button (B4) flashes rapidly,
indicator (B9) lights up.