Table of Contents
Advertisement
•
It is not possible to make a
pre-ground coffee.
7.4 General indications for making coffee-
based drinks
•
Indicator lights may appear on the control panel (B) dur-
ing use. Their meaning is given in section "16. Explanation
of lights".
•
For hotter coffee, see section "7.7 Tips for a hotter coffee".
•
If the coffee is delivered a drop at a time, too weak and
not creamy enough or too cold, read the tips in section
"17. Troubleshooting".
•
To customise the drinks according to personal taste, see
sections "7.5 Varying the coffee intensity" and "7.9 Cus-
tomising the quantity in the cup".
Please note:
In energy saving mode, a few seconds may elapse before the
first coffee is delivered as the appliance must heat up again.
7.5 Varying the coffee intensity
1. Press the
button (B5) repeatedly until the Leds
relative to the desired intensity light up (B6):
2. Select the desired coffee drink.
Please note:
•
When the next coffee is made, the machine will show the
last intensity setting selected.
•
In the event of power failure, the machine will revert to
the medium default setting.
7.6
Rinsing
Use this function to deliver hot water from the coffee spouts to
clean and heat the appliance's internal circuit.
1. Place a container of at least 100ml capacity under the cof-
fee spouts (A15) (fig. 6).
2. To perform the rinse cycle, simply press the
(B2) and hold for about 5 seconds. The cycle will star and
stop automatically (to terminate the cycle sooner, press
the same button a second time).
Doppio+ coffee using
Mild
Medium
Strong
button
Please note:
•
If the appliance is not used for more than 3- 4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
•
It is normal for the grounds container (A10) to contain
water following a rinse cycle.
7.7 Tips for a hotter coffee
To make a hotter coffee, proceed as follows:
•
run a rinse cycle (see section "7.6 Rinsing
•
warm the cups by rinsing them first using the hot water
function;
•
increase the coffee temperature (see section "12. Settings
menu").
7.8 Adjusting the coffee mill
The coffee mill does not require any adjustment, at least initial-
ly, as it has been factory set to ensure that coffee is prepared
correctly.
To make an adjustment while the coffee mill is in operation,
turn the dial (A2) as follows:
If the coffee is delivered too
slowly, or not at all.
This adjustment will not take ef-
fect until at least 2 cups of coffee
have been delivered.
For a fuller bodied creamier
coffee
This adjustment will not take ef-
fect until at least 2 cups of coffee
have been delivered.
Please note:
The adjustment dial must be turned only when the coffee mill
is in operation during the initial step of coffee preparation.
7.9 Customising the quantity in the cup
1. Press the button relative to the drink being programmed
and hold for a few seconds: when the Led corresponding
to the selection starts flashing rapidly, the machine is in
programming mode. Delivery begins;
2. Once the cup is filled to the desired level, press the drink
button again. Delivery ceases and the quantity is stored
in the memory.
Please note:
To cancel the current setting, press a button corresponding to an-
other drink
8
");
Turn one click towards "7"
Turn one click towards "1"
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
