Making Cappuccino; What Milk To Use; Clean The Steam/Hot Water Spout After Use; Delivering Hot Water - DeLonghi MAGNIFICA START ECAM22 2 Series Instructions For Use Manual

8. MAKING CAPPUCCINO

8.1 What milk to use

The quality of the froth will vary depending on:
• the temperature of the dairy or vegetable milk used
(for best results, always use dairy or vegetable milk
straight from the fridge: 5 °C);
• the type of dairy or vegetable milk;
• the brand used;
• ingredients and nutritional value.
8.2 Making cappuccino
1. Fill a container with about 100 ml of milk for each cappuc-
cino to be prepared (13) . When choosing the size of the
container, bear in mind that the milk doubles or triples
in volume.
ml
2. Immerse the cappuccino maker (A17) in the milk
container.
3. Press the button: Steam (B8).
4. Wait until the Led relative to the
flashing rapidly: now turn the steam/hot water dial (A19)
to the I position (fig. 14).
5. After a few seconds, steam is delivered from the cappuc-
cino maker, giving the milk a creamy frothy appearance
and making it more voluminous. For a creamier froth,
rotate the container with slow movements in an upward
direction.
6. Once the froth is as required, shut off the steam by turning
the dial to the 0 position.
7. Prepare the coffee in a large cup.
8. Add the frothed milk to the coffee. The cappuccino is
ready. Sweeten to taste and, if desired, sprinkle the froth
with a little cocoa powder.

8.3 Clean the steam/hot water spout after use

Clean the steam/hot water spout (A16)every time it is used,
to prevent the build-up of milk deposits and prevent it from
clogging.
13
Steam button starts
Danger of scalding!
When cleaning the steam/hot water spout, a little hot water
will be released. Take care to avoid contact with splashes of
water.
1. Release a little water by turning the steam/hot water dial
(A19) to the I position. Then shut off the flow by returning
the dial to the 0 position.
2. Wait a few minutes for the spout to cool down. Turn the
cappuccino maker (A17) anti-clockwise and pull down to
remove (fig. 15).
3. Pull the nozzle (A18) downwards (fig. 16).
4. Make sure the two holes arrowed in fig. 17 are not
clogged. If necessary, clean using a toothpick.
14
5. Reinsert the nozzle and reconnect the cappuccino maker
to the nozzle, pushing upwards and turning clockwise until
the two engage.

9. DELIVERING HOT WATER

Danger of scalding!
Never leave the machine unattended when hot water is being
released. The tube of the steam/hot water spout (A16) heats
up when in use.
1. Position a container under the steam/hot water spout (as
close as possible to avoid splashes).
2. Turn the steam/hot water dial (A19) to the I position (fig.
14).
3. To shut off the flow of hot water manually, turn the
steam/hot water dial to the 0 position.
9
15
17
16