Description Of Control Panel - B; Description Of Accessories - C; Setting Up The Appliance - DeLonghi MAGNIFICA START ECAM22 2 Series Instructions For Use Manual

A9. Water tank
A10. Coffee grounds container
A11. Drip tray
A12. Drip tray water level indicator
A13. Cup grille
A14. Condensate tray
A15. Coffee spouts (adjustable height)
A16. Steam/hot water spout
A17. Cappuccino maker (removable)
A18. Steam/Hot water connection nozzle (removable)
A19. Steam/Hot water dial
A20. Cup shelf

2.2 Description of control panel - B

B1. ON/standby button with built-in Led
B2. X2 button with built-in Led (if pressed and held for 5 sec-
onds, activates rinsing of the coffee circuit)
B3. Settings menu button with built-in Led
B4. Descale button with built-in Led
B5. Intensity or Pre-ground selection button
B6. Intensity selection Led
B7. Pre-ground selection Led
B8. Different numbers and types of drinks, according to
model.
B9. Indicator permanently alight: filter must be replaced
Indicator flashing: filter replacement in progress
B10. Indicator permanently alight: insufficient water in the
tank (A9)
Indicator flashing: tank not in position
B11. General alarm indicator
B12. Indicator permanently alight: grounds container (A10)
needs emptying
Indicator flashing: grounds container not in position
B13. Indicator permanently alight: machine must be descaled
Indicator flashing: descaling in progress

2.3 Description of accessories - C*

(number and type differ according to model)
C1. "Total Hardness Test" indicator paper
C2. Pre-ground coffee measure
C3. Descaler

3. SETTING UP THE APPLIANCE

Please note:
• When using the machine for the first time, all removable
accessories making contact with water or milk should be
rinsed with hot water.
• Possible traces of coffee in the mill are the result of op-
erating tests performed on the appliance before sale,
proof of the meticulous care and attention we invest in
our products.
• The first time the machine is used, the water circuit will
be empty and the appliance could be very noisy.The noise
becomes less as the circuit fills.
Make sure that the steam dial (A19) stays in the 0 position
•
until completion of the first start-up cycle (fig. 1).
1. Connect the appliance to the mains supply (fig. 2).
2. The indicator
(B) (fig. 3): remove the water tank (A9) (fig. 4), fill up to
the MAX level with fresh water (fig. 5), then reposition in
the appliance.
3. The Led (B3) on the control panel will flash rapidly.
4. Position a container under the coffee spout (A15) (fig. 6).
5. Press the
circuits start to fill and the appliance will release hot water
from the coffee spout.
5
1
1 2 3
2
(B10) will light up on the control panel
4
button(B3) (fig. 7): the internal water
4 5
3
5