Intermec Trakker Antares 2400 Quick Reference Manual

Troubleshooting
If you are unable to establish a good connection or the
green Power Status Light is not on, make sure you
have:
• Set the serial port parameters (for example, baud
rate) to match between the terminal and the device.
• Connected the correct serial cable.
• Ensured that the electrical outlet has power.
• Inserted the terminal firmly in the dock.
• Connected the external power supply to AC
power.
• Cleaned the optical interface windows and ports on
both the terminal and the dock.
• Cleaned the three pins on the dock where you insert
the terminal.
RS-232 Connector Pinout Description
J1
RXD (Receive data)
2
3 TXD (Transmit data)
DTR (Data terminal ready)
4
5 GND (Signal ground)
7 RTS (Request to send)
CTS (Clear to send)
8
2400Q.005
Physical and Environmental

Specifications

xw12V 750mA
Electrical requirements:
Interface: 9-pin D RS-232
Optical interface: 2 IR receivers and 2 IR
transmitters
Optical RS-232 interface: Converted RS-232 bipolar
signals to optical signals
and vice versa
Interface speeds: Baud rate up to
38400 baud
Operating environment
Charge Temperature: 32°F to 104°F (0°C to 40°C)
Operating Temperature: -4°F to 122°F (-20°C to 50°C)
Humidity: 0 to 95%, non-condensing
Storage environment
Temperature: -4°F to 158°F ( -20°C to 70°C)
Humidity: 0 to 95%, non-condensing
Note: The lithium-ion battery pack in the terminal will
not charge below 32°F (0°C).
Design and specifications are subject to change without
notice.
Warning
To prevent fire or electric shock, do
not expose the TD2400 to rain or
moisture.
Avertissement
Pour éviter des risques d'incendie
ou de choc électrique, ne pas exposer
le TD2400 à la pluie ou à l'humidité.
6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280
© 1998 Intermec
All Rights Reserved
P/N 065555-004
TRAKKER ®
Antares TD2400
™
Communications Dock
The TRAKKER Antares TD2400 Communications Dock
is an accessory for the TRAKKER Antares 2420 and 2425
(T2420 and T2425) hand-held terminals. The dock lets
you transfer data and applications to and from another
device by using RS-232 serial communications. The dock
will also charge the batteries inside a T2420 or T2425 that
is inserted into the dock.
This guide describes how to install and use the TD2400
communications dock. Before using the dock, please
read this guide thoroughly and retain it for future
reference.
Quick
Reference
Guide
2400Q.006